How to use TheraNeck 2.0

Dear customer, thank you once again for your order.

TheraNeck 2.0 has been designed for simple, intuitive use from the very first session.

On this page, we'll explain exactly how it works and how to get the most out of it based on your individual needs.

#1 Get ready for your treatment

Turn on TheraNeck 2.0 by pressing the dedicated button on the remote control, then lie down on the device.

Your head should rest on the red LEDs.

We recommend using TheraNeck 2.0 on a firm surface, such as a floor or a rug.

#2 Personalise your treatment

TheraNeck™ 2.0 comes with the following therapeutic modes, in addition to static and dynamic traction:

  • EMS: up to 9 intensity levels
  • Therapeutic heat: up to 3 intensity levels
  • Deep massage: up to 3 intensity levels

To adjust the intensity of each mode, you can use the buttons on the remote control.
The selected intensity level will be shown on the display.

#3 Choose between static and dynamic traction

Once you've selected your desired EMS, heat and massage levels, all that's left is to choose whether to use TheraNeck 2.0 with static or dynamic cervical traction.

If you choose static traction, press the dedicated button on the remote control.

You can select from three different traction angles, depending on your needs:

  • Level #1: low traction angle
  • Level #2: medium traction angle
  • Level #3: maximum traction angle

The selected level will be shown on the display.

If you choose dynamic traction, press the dedicated button on the remote control.

You can select up to three different traction speeds:

  • Level #1: fastest speed
  • Level #2: medium speed
  • Level #3: slowest speed

The selected level will be shown on the display.

Once you've selected your preferred dynamic traction level, wait a few seconds for the device to begin carrying out the command.

CLEANING

  • Wipe with a damp cloth while the device is switched off. Allow to dry fully before using again.
  • Do not immerse the device in water.